Replace hard disk

The hard drive can be replaced by hand, as it is only connected with a SATA cable.


Hard disk replacement

  1. Loosen the screws on the housing (1 screw per side, 3 screws on the back).


  2. Remove the case.

  3. On the underside of the recorder are 4 screws that hold the hard drive. These have to be removed.


  4. Carefully pull the hard disk out of the SATA slot.


  5. Installation is the reverse order.

  6. The hard drive must be formatted after the replacement. Follow our guide "Format HDD".
Was this article helpful?
54 out of 57 found this helpful
Have more questions? Submit a request