Setting up the camera Wi-Fi adapter (PWA)

By default, the PWA is connected to your router using WPS. If the router does not have WPS functionality, you can manually integrate the PWA into your wireless network.


Step 1: integration via WPS button

  1. Press the WPS button on your router.

  2. Plug the PWA into a socket and then press the WPS button on the bottom of the adapter.

  3. During the connection, the WPS LED flashes green. If the connection is successful and the camera is connected to the adapter, all LEDs light up green.

weight_wps.jpeg   weight_front.JPEG


 Step 2: Manual configuration (no WPS available on the router)

  1.  Plug the PWA into a socket and connect your computer directly to the PWA with a LAN cable.
  2. Adjust the IP configuration of your computer to that of the PWA to carry out the configuration:

  3. In Windows open the network and Sharing Center > Change adapter settings > Right click on the adapter > Properties > Internet protocol TCP / IP V4 > Properties > Use the following IP address.

  4. Enter the following data:

    • IP address:
    • Subnet mask:
    • Default gateway:
    • Primary DNS:
    • Secondary DNS:
  5. Save the settings and open a browser.

  6. Type to connect to the web interface of the PWA.

  7. Enter admin as the user and admin as the password.

  8. Navigate to Settings and then select LAN and change the WORK MODE to Server.

  9. Check the settings and then click Save & Apply:

    • IP address:
    • Subnet mask:
    • Default Gateway:
    • DHCP Client Range: -
    • Lease Time: 480
    • Static DHCP: Set Static DHCP
    • 802.1d Spanning Tree: Off
  10. Switch to the Wi-Fi menu and enter your network data there to integrate the PWA into your network.

  11. Set the computer's IP address from step 4 back to the default values.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request